Diamond Grit Impregnated Dressers, Diamond Grit Impregnated, Diamond Grit Impregnated Dressers Manufacturer, Mumbai, India
 
 
 
 
 
 

  Diamond Grit Impregnated Dressers

 
 

Diamond Grit Impregnated Dressers have been developed from multi-point dressers. In contrast to the latter they are manufactured from diamond grit rather than a larger number of small natural diamonds. The advantages of the diamond impregnated dresser lie in its exceptional sharpness, which results from sharp edges and points of the diamond grit.

Diamond grit impregnated dressers are ideally suited to the following applications, dressing resin, vitreous and rubber bond, fine grit and even "grit free" grinding wheels, as well as boron carbide grinding wheels, dressing single profile threaded and V-profile grinding wheels, for general dressing operations on centreless, cylindrical and surface grinding machines.

Diamond grit impregnated dressers are more economical because of their low initial cost and their resistance to shock and impact which prevents shattering.

Dressing times are reduced as higher feed rates can be used. There is an unlimited number of
sharp pull-out-free cutting edges contained in the crushed diamond grit.

Diamond grit impregnated dressers demand greater care in selecting the correct dresser for a given application. The bond and diamond grit size used are both variable according to the type of grinding wheels to be dressed. The size of the diamond grit particles should be matched to the grit size of the grinding wheel.

Instructions for Use:
Normal dressing speeds are used. A plentiful supply of coolant should be provided both before and during dressing to prolong dresser life. The diamond grit impregnated cutting face of the dresser should be set at an angle of 90° to the grinding wheel to be dressed, so that all the cutting edges of the diamonds grit are able to make contact with the wheel face.

The feed rates used may be double of those used with single-point diamond dressers.

 
Diamond Grit Impregnated Dressers
 The Depth Of cut Should Be as Follows
Finishing   - approx  0.01 mm
Rough grinding - approx 0.02 mm
 
     Get Free Quote Now ...

 

 
 
 
 
Office : 213, Bhaweshwar Complex,   Opp. Railway Station, Vidyavihar (West), Mumbai - 400 086, Maharashtra, INDIA.  
Tel. :
00-91-22-2515 4744 / 2513 6660   Fax : 00-91-22-2511 3166,

Web - | www.solardiamondtools.com | www.diamondtool.co.in |